Russell Professional Pond Products
SH-5100 Pond and Waterfall Pump 5,100 gph @ 5' with Optional Auto ON/OFF Float Switch
Optional Float Switch:Pump Only
Quantity:
SH-5100 Pond and Waterfall Pump
High-Volume Direct Drive Submersible Pump
- High efficiency motor
- 5,100 gph @ 5′ head
- 2″ female threaded outlet
- 1/2 horsepower
- 37′ max head
- 115 volt, 5.5 amps
- 506 input watts
- ETL listed
- Heavy-duty motor designed for continuous duty operation
- Cast aluminum bearing housing
- Non corrosive construction
- Anti vibration bearing technology
- Dual mechanical shaft seals - Silicon carbide lower, carbon ceramic upper
- 33' heavy duty power cord
- Vortex impeller
- Stainless steel housing
- Stainless steel shaft
- Stainless steel fasteners
- 3,400 rpm motor
- Double ball bearings
- $36.30 monthly operating cost @ $0.08 per kilowatt hour
- 2 year warranty
- Use with CVA-200 Custom Cam Lock Check Valve Assembly for HydroClean Pond Skimmers and HydroChamber Pump Vault
- Optional Auto ON/OFF Float Switch helps prolong pump life by preventing low water operation
SH-5100 Pond Pump Flow Rate GPH @ Head
| SH-5100 | 0' | 5' | 10' | 15' | 20' |
| GPH | 5,100 |
5,100 |
4,320 | 3,420 | 2,700 |
SH-5100 Pond Pump
Reliable and dependable 5,100 gph
Pond and Waterfall Pump
Reliable and durable 5,100 gph @ 5' pump for ponds and pondless waterfalls. Heavy duty continuous duty operation. The SH-5100 pond pump is constructed of stainless steel and corrosion resistant fiber reinforced resin. Quiet operation and large water flow makes the SH-5100 a great choice for pondless waterfalls and all types of ponds.
Electrical
- Pump must be protected by a ground fault circuit interrupter (GFCI).
- Pump must be plugged into a standard, properly grounded, three pronged outlet. Pump MUST NOT BE HARDWIRED.
- Do not cut or alter the electrical cable.
- Never move or handle the pump by pulling on the electrical cable. Make sure the electrical cable does not become excessively bent or twisted, does not rub against a structure in a way that might damage it, and does not come in contact with heated surfaces.
- Upon receipt of pump - examine the cable for damage from shipping. If damaged, contact us immediately for a replacement. DO NOT INSTALL a pump with a damaged electrical cable!
- Cutting or altering electrical cable in any way VOIDS the warranty. Installing a pump with a damaged cable VOIDS the warranty.
Operation
- Pay careful attention to the water level while the pump is operating. Dry operation may cause the pump to malfunction. Pump must always operate while fully submersed. Pump failure due to dry operation VOIDS the warranty.
